LTPRHP3W-R

Specification	Value
Active area diameter	11 (mm)
Light color, peak wavelength	red, 625 nm
Spectral FWHM	20 (nm)
Illuminance	9 (klux)
Operating mode	Continuous and strobe
Supply voltage	12-24 (V)
Power consumption	4.5 (W)
LED forward voltage typical (max)	2.4 (3) (V)
Max LED forward current	720 (mA)
Max pulse current	2000 (mA)
Estimated MTBF	> 100000 (hours)
Connector	M8
Cables	CB244P1500 included
Mount	C
Phase adjustment	Yes
Diameter	38.5 (mm)
Length	90.8 (mm)
Mass	153 (g)
Operating temperature	0-40 (°C)
Storage temperature	0-50 (°C)
Operating relative humidity	20-85, non condensing (%)
Installation	Indoor use only
Risk group according to CEI EN 62471:2010	Exempt

Description

With a 35 mm lens, F/N 1.4 at 100 mm working distance without projection pattern at maximum driving current. Estimated value.
To pulse LTRPHP3W, models built-in electronics must be bypassed in order to drive the LED directly.
Tolerance ± 10%
At max forward current. Tolerance is ± 0.06V on forward voltage measurements
Max continuous LED driving current is supplied through the built-in electronics. No external controller is required.
At pulse width <= 10 ms and duty cycle <= 10%. Built-in electronics board must be bypassed (see tech info)
At 55 °C, 720mA.

Mount	C
Color	red, 625 nm
Light color, peak wavelength	red, 625 nm
Max pulse current	2000 (mA)
Accessory developer	Opto
Active area diameter	11 (mm)
Mass	153 (g)
Length	90.8 (mm)
Connector	M8
Supply voltage	12-24 (V)
Operating temperature	0-40 (°C)
Storage temperature	0-50 (°C)
Installation	Indoor use only
Lens mount	C
Risk group (cei 62471)	Exempt
Phase adjustment	Yes
Operating relative humidity	20-85, non condensing (%)
Spectral fwhm	20 (nm)
Illuminance	9 (klux)
Power consumption	4.5 (W)
Cables	CB244P1500 included
Estimated mtbf	> 100000 (hours)
Led fwd volt (typ/max)	2.4 (3) (V)
Max led forward current	720 (mA)
Operating mode	Continuous and strobe
Diameter	38.5 (mm)
Operation power source